料气英语怎么说

admin2024年11月28日中英词典3200

本文为您带来料气的英文翻译,包括料气用英语怎么说,料气用英语怎么说,料气的英语造句,料气的英文原声例

本文为您带来料气的英文翻译,包括料气用英语怎么说料气用英语怎么说料气的英语造句料气的英文原声例句料气的相关英语短语等内容。

料气的英文翻译,料气的英语怎么说?

  • 料气

  • Liu qi

  • 以上为机器翻译结果,长、整句建议使用 人工翻译 。

料气的英语网络释义

料气的汉英大词典

料气的英语短语

  • 燃料气[油气]fuel gas;FG

  • 原料气virgin gas;feed gas;Raw gas & Syngas

  • 粉料气力输送装置[建]filler pneumatic conveyer

  • 塑料气球plastic balloon

  • 固体燃料气化solid fuel gasification

  • 塑料气泡机plastic air bubble machine

  • 氧燃料气焊接oxy-fuel gas welding;fuel gas welding

  • 原料气压缩机feed gas compressor;raw gas compressor

  • 燃料气加热器fuel gas heater

料气的英文例句

介绍力输送管道的变径设计方法和变径管道力输送试验中压损、比、物质量流量等间的关系。

A method of stepped-diameter design for pneumatic conveying pipelines, as well as relationship among pressure loss, ratio of material to air, and mass flow rate of materials etc.

针对长江原水浊度较高的特点,采用了两级高效反应沉淀池、均质石英砂滤料气水反冲洗滤池处理工艺。

Considering the high turbidity of the Yangtze River water, two-stage high efficient reaction and sedimentation tanks, and sand filter with air-water backwashing are employed.

本文介绍了“原位冷凝”式弹丸注入器先行实验及中国环流器一号HL-1弹丸加实验中采用的丸和推进剂系统;

In this paper, the fuel gas and propellent system of "in site" Pellet injector used in beforehand experiment and Pellet fueling experiment in HL-1 Tokamak has been introduced.

所以DCT设计的送系统使用“刀”“冠状物”和真空吸盘来分离和吸取这些片。

So DCT produces blank feeding systems that use "air knives," "rooster combs," and vacuum lifting to separate and lift the sheets.

产品与其它外加剂相容性好,与膨胀剂、引剂等外加剂及粉煤灰等活性掺合相配合,功能相互补充、相互激发。

Good compatibility with other admixture products, and expansive agent, air-entraining agent admixtures fly ash and such activities admixtures suitably, function complement each other, mutual arousal.

在二相流雾化器的结构设计中,雾化输送器件和液输送器件的管径及其径向夹角是其设计的关键。

The diameter of atomizing gas duct and liquid feedstock duct and their crossing angle are vital elements in the design of two phases atomizing nozzle.

放卷、收卷均由胀轴支撑卷,更换快捷、撑力均匀、定心准确。

The unwinding equipment and rewinding equipment all adopt air-expansion shaft to bear roll materials, assuring fast replacement, even supporting force and accurate centering.

即主要通过混凝和短时直接曝对待处理的生活污水作预处理,然后通过河沙或炉渣滤进行过滤处理。

That is, use coagulation and direct aeration in short time for primarily treatment of domestic sewage, then filter domestic sewage by slag filtration or sands.

基于边界条件替换方法建立了高炉冷却壁本体和捣打与炉之间的换热系数计算模型。

A calculation model of the coefficient of heat transfer between gas and stave body and inlaid refractory is built based on the substitution method of boundary condition.

在连续给外热式回转窑试验台上,以聚乙烯为试验物进行了热解产特性、质量平衡以及能量净收益的试验研究。

By the continuous-feeding external-heating rotary kiln, the experimental studies on the gas yield characteristics, mass balance and net energy income of the polyethylene pyrolysis were performed.

通过对PTA送糟仓的结构进行疲劳分析和优化,从根本上解决了其裂纹和焊缝撕裂现象。

The problems were essentially resolved through fatigue analysis and optimization of the structure of feed bin of PTA pneumatic transmission channel.

本文用液上相色谱法在不同温度下测定了不同中和度的含SO42-0~4%的磷铵浆的平衡氨分压。

In this paper, ammonia equipressures of ammonium phosphate slurry under different neutralization degree and SO42- cone entration(0~4%) are determined using headspace gas chromatography.

研究了顶层进均匀性、进及排方式对多层流化床流化层高度均匀性的影响。

The top material admission balance, gas admission, gas exhaust effect of the uniformity of fluidized heights in multistage fluidized bed were studied.

的钎焊性能很大程度取决于钎对基板上的润湿性能,而润湿性能与液态钎在基板上的液、固、三相界面的界面张力有关。

The solderability of electronic solders depends to a great extent on the wettability, which relates to solid, liquid and gas interfacial tensions of the melted solders on substrates.

利用隙式膜蒸馏实验对液温度、流率及隙宽度等操作条件对膜渗透性能的影响进行了测试和分析。

The effects of operation conditions , such as the temperature and flow rate of solution and the width of air-gap on membrane permeability were studied by air-gap membrane distillation.

液混合腔内的雾化流的速度和液流量进行了计算。

Thevelocity of atomizing gas and the flux of liquid feedstock were accounted.

的钎焊性能很大程度上取决于钎对基板的润湿性能,而润湿性能与液态钎在基板上的液、固、三相界面的界面张力有关。

The solderability depends on a great extent on the wettability, which relates to solid, liquid and gas interfacial tensions of the melted solders on substrates.

利用隙式膜蒸馏考察了操作温度、液中难溶盐种类及其饱和度以及液中不溶颗粒等因素对膜渗透性能的影响。

The effects of operation temperature, salt type, saturation level, and the presence of undissolving solids on the membrane permeability were studied by air-gap membrane distillation.

并且提出负离子元素在膜蒸发过程中形成源中心,产生喷溅,从而使薄膜的损伤阈值降低。

The negative ion element will become the gas source center and form an ejection in the process of evaporation of coating material, so decrease the damage threshold of the coatings.

介绍聚丙烯“三井工艺”相反应器产生块的原因、预防措施及解决办法。

The cause of undesirable block material in PP gas phase reactor is introduced in the paper, relevant prevention measures and solutions are also introduced.

本文研究了脉冲惰熔融测定钼中微量氧所用的浴

The metal bath to determine microamount oxygen in molybdenum by impulse heating under inert gas is investigated.

它比传统沼池产率提高30%,可自动出,永不换

It digesters than traditional gas yield increased by 30%, can automatically feed out and never refueling.

阐述了曝生物滤池的基本结构、工艺流程、工艺特点及对滤性质的要求。

This paper expounds the basic structures, technological processes, technical features of biological aerated filter and the requirements for the natures of the filter materials.

熔融提过程中选用适当的浴,可以提高氮氧的释放提取率。

If the suitable bath is applied to heating and extracting procedure, the extracting ratio can be increased.

在冷态试验台上研究了循环流化床腿密相段中不同管束布置方式对固流动特性的影响。

The influence of the arrangements of pipes on gas solid flow characteristics in the dense section of standpipe in the circulating fluidized bed is studied on a cold state experiment platform.

用植绒PV C经高频热压成型,倒阀门嘴,具有双层防漏功能。

PVC flocking materials used by high-frequency hot press molding, gas valve back up, with both gas permeability and gas leak-proof function.

本文讨论了不同补成分对主要微生物生理群和产率的影响。

This paper studied the effect of different materials added during fermentation on the activity of major bacteria physiologic groups and gas-production rate.

为进一步提高聚乙烯粒包装系统淘析器的分离效率,对系统内相流场进行了研究和分析。

Three-dimensional flow field in the elutriator of polythene packed system is simulated based on the standard k-e model provided by FLUENT, is studied firstly to improve the separation efficiency.

为进一步提高聚乙烯粒包装系统淘析器的分离效率,对系统内相流场进行了研究和分析。

Three-dimensional flow field in the elutriator of polythene packed system is simulated based on the standard k-e model provided by FLUENT, is studied firstly to improve the separation efficiency.

料气的原声例句

料气的网络释义

很抱歉,暂无字的网络释义。

以上关于料气的英语翻译来自英汉大词典,希望对您学习料气的英语有帮助。

返回列表

上一篇:料然英语怎么说

没有最新的文章了...