死点英语怎么说

admin2024年11月24日中英词典5000

本文为您带来死点的英文翻译,包括死点用英语怎么说,死点用英语怎么说,死点的英语造句,死点的英文原声例

本文为您带来死点的英文翻译,包括死点用英语怎么说死点用英语怎么说死点的英语造句死点的英文原声例句死点的相关英语短语等内容。

死点的英文翻译,死点的英语怎么说?

  • dead point ; dead center ; dead spot

死点的英语网络释义

当水中溶氧量低于3.5mg/L时,则会窒息死亡,在夏季水中溶氧3mg/L,被视为是虹鳟的死点 (dead point),适于虹鳟良好生长的最佳溶氧量为6~10mg/L。溶氧在5mg/L以下时,则食欲不振,食量大减。

在这50项成就中,有两个名字格外引人注目,一个是死点Dead Center),一个是暴雨

... dead spot 死点 dead-stick landing 停车着陆;熄火迫降 dead storage 封存 ...

死点的汉英大词典

死点[sǐ diǎn]

  • {机} dead center; {电} dead spot; {生} dead point
  • 短语:
    • 死点标记 dead-center mark;
    • 死点发火 dead-center ignition;
    • 死点位置 mid-gear; middle gear;
    • 死点压力 dead-end pressure

死点的英语短语

  • 上死点top stop;[机]top dead center;upper dead center

  • 上死点前before top dead center;bofore upper dead centre;BTDC

  • 热死点thermal death point

  • 死点位置dead center position;Dead Point Position;middle gear;dead-center position

  • 致死点death point;lethal point;zero point

  • 外死点outer dead point;o-xylene;[动力]outer dead-centre;ODP

  • 死点.止点dead point

  • 下止点.下死点bottom dead center

  • 内死点inner dead point;IDP InnerDeadPoint;IDP;inner dead center

死点的英文例句

甘多人死点解唔见你死!

Many people die never see you die.

而这时阀内有一个停止块来防止阀瓣超过上死点而打开。

But this time there is a stop block valve to prevent valve flap over top dead center and open.

经过优化设计,电机工作性能稳定,无死点,调速平稳。

Stable performance, no dead point, smooth speed adjustment due to optimization design.

另外,球塞(6)设置在靠近活塞上死点的活塞环所在的部位。

Moreover, the ball plungers (6) are positioned near the piston top dead center, at which the piston ring is positioned.

提出了一种齿轮齿条机构产生匀速往复直线运动并能克服死点的方法。

The mechanism is made up of gear and gear rack can get rid of dead point.

在实际开窗过程中,常常会遇到窗口开偏、开窗提前结束、突破死点等问题。

In the practical opening procedure, we'll be confronted with these problems such as deviated window, opening ended ahead and how to break though the dead point.

但如果击中的正好是竹身的中心,也就是所谓的死点,那么会发出特殊的撞击声。

But if it hit the trunk dead centre, it would make a distinctive "clonk".

打破了原来的“死点开,停”的控制方式,保证了机房要求的高精密的温湿度。

Broke original "dead spots open, stop" control mode, guarantee the room of high precision of temperature and humidity requirement.

打破了原来的“死点开,停”的控制方式,保证了机房要求的高精密的温湿度。

Broke the original "dead spots open, stop" control mode to ensure that the requirements of the engine room of the high-precision temperature and humidity.

此外,在所有负载条件下将活塞操作在上死点和共振状态,从而进一步增加操作频率。

Further, the piston is operated at the top dead center position and in the resonance state under all load conditions, thereby further increasing operation frequency.

踢水次数也显著增加,显示游泳者必须更努力的踢水以维持划水间隙中的“死点”的速度。

The kick rate also increased significantly, suggesting the swimmer had to start kicking harder to maintain speed in the dead-spot created between strokes.

使用这个方法,单元会漫步于死点位置,重复做相同的错误选择,直到他们发现周围的路。

Using this approach, units will wander down dead ends and make similar wrong choices until they have learned their way around.

在曲柄摇杆机构中,当以摇杆为原动件时,工作一个循环以后,直观看出有两次死点位置出现。

In the crank and rocker mechanism, when the rocker acts as the driving link, there will be two dead points in one working cycle.

机构的死点位置在机械中很常见,解决死点位置的精度问题对于精密压力加工无疑是非常重要的。

The dead point position of mechanism is a common sight. Undoubtedly, it is very important for precise press-working to solve the problem of dead-point precision.

由于曲柄只作有限度的来回摆动,从而克服了圆周运动中的死点,并能在最理想的角度范围内作功。

Because the crank only swings back and force within limit, therefore, the dead center in circular motion is overcome, and the crank can make power in the most ideal Angle range.

本实用新型具有结构简单、成本较低、磨损小的优点,且不会出现死点现象,延长 了使用周期。

The utility model has the advantages of simple structure, low cost, little wear and tear, no dead point phenomenon and long service life.

研究表明:系统的压力生成能力不仅与密封间隙相关,同时与系统的死点容积、增压速度及排液容积相关。

The studies show that the ability of systemic pressure generation is involved with sealing clearance, dead center volume, pressure intensifying speed and volume of discharged oil.

在公开水域试图过分延长划距可能使你在划水间隙中的“死点”停滞。尽管你努力划水,仍然会渐渐落后。

Try and overly lengthen your stroke in open water and you can literally be stopped dead in the gap between your strokes and you will slip to the back of the field despite working hard.

而且对于非正规世界,我们一方面可以把它们理解成死点,但另一方面我们也可以通过构造性的方法证明其不是死点

We can regard abnormal worlds as dead points but on the other hand we can use a constructive way to prove that they're not dead points.

为了有效地控制直线冰箱压缩机的活塞位移,提出了一种以活塞上死点位移为控制目标的可自调整规则的模糊控制系统。

In order to effectively control the piston displacement of a linear refrigerator compressor, a new fuzzy control system based on self-adjusting was proposed.

有无马赛克、死点景象马赛克是指显现屏上呈现的常亮或常黑的小四方块,既模组坏死景象,其主要原由于显现屏所选用的接插件质量不过关。

Three, there is no Mosaic, Mosaic dead scene appears on the screen is often bright or black box is often small, necrosis of the primary module scene, because the screen selected connector quality.

但仔细观察,就会发现在他们的划水技术中,没有踉跄,没有暂停,更没有被钩住和死点——他们拥有优秀的节凑和时机,正无缝地从一个相位转到另一个相位。

But look carefully, there are no lurches, pauses, hitches or dead spots in their stroke technique - they have excellent rhythm and timing, moving seamlessly from one phase of the stroke to the other.

但仔细观察,就会发现在他们的划水技术中,没有踉跄,没有暂停,更没有被钩住和死点——他们拥有优秀的节凑和时机,正无缝地从一个相位转到另一个相位。

But look carefully, there are no lurches, pauses, hitches or dead spots in their stroke technique - they have excellent rhythm and timing, moving seamlessly from one phase of the stroke to the other.

死点的原声例句

死点的网络释义

死点 从Ft=Fcosα知,当压力角α=90°时,对从动件的作用力或力矩为零,此时连杆不能驱动从动件工作。机构处在这种位置成为死点,又称止点。死点就是处于直线位置上。

以上关于死点的英语翻译来自英汉大词典,希望对您学习死点的英语有帮助。